GEAR (33 Teeth) 8S2134 - Caterpillar

15. Install the two seal rings and an O-ring seal on each of two covers (14).16. Put the covers in position as shown and install the eight bolts that hold the covers in position. 17. Install two tube assemblies (15). 18. Install two 1/2"-13 NC forged eyebolts in bearing cap (16). Fasten a hoist to the bearing cap and install it on the housing with four bolts.19. Tighten four bolts (17).20. Install a 1/2"-13 NC forged eyebolt in bearing cap (18). Fasten a hoist to the bearing cap and install it on the housing with four bolts. 21. Tighten eight bolts (19). 22. Install tube assemblies (20).23. Install the gaskets and put 7M7260 Liquid Gasket on the contact surfaces of top cover (21) and the front cover.
When top cover (21) is installed be careful not to damage the gaskets on the two rear covers (22).
24. Install two 1/2"-13 NC forged eyebolts in top cover (21). Fasten a hoist