GEAR AS-RING 8S9085 - Caterpillar

Indicators
(1) LOW AIR PRESSURE INDICATOR (RED) Indicates that the air pressure is too low. Below 60 psi (415 kPa), the indicator will light, and a warning horn will sound.
Stop the machine immediately if the light goes on, and/or the horn sounds. Have repairs made if the air pressure will not build-up.
(2) LOW COOLANT FLOW INDICATOR (RED) Indicates the engine coolant flow has stopped. If the coolant flow stops, the light will go on and the air horn will sound.This could indicate a stalled engine, water pump failure or coolant leak.
If the light goes on, and/or the horn sounds, stop the machine and the engine. Have repairs made before starting the engine.
A flickering light could indicate low coolant level. (1) AIR FILTER SERVICE INDICATOR Indicates that the air flow to the engine is restricted. Service the air cleaner any time the red band is visible in the indicator. Push the button at the bottom of the indicator to reset it after servicing the elements.Switches
(2) WINDSHIELD WIPER Turn the switch to the right to the first position. The wiper will operate slowly. Turn the switch farther to the right, to the second position. The wiper will operate faster.Switches
(1) LIGHT SWITCH Turn the switch to the right to the first position. Only the dash lights will come on.Turn the switch to the second position. The headlights, flood light and dash lights will come on.(2) HEAT-START SWITCH Push the switch in and to the left (HEAT position), for glow plug heat.Push the switch in and to the right (START position), to crank the engine.
Do not move the switch to the HEAT position with the engine warm and running.
(3) HORN BUTTON Push the button to sound the air horn. (1) HEADLIGHT DIMMER Depress and release the button for low beam headlights, when the headlights are on high beam.Depress and release the button again to return to high beam.Use low beam when meeting oncoming traffic. (2) BATTERY DISCONNECT Disconnects all electrical components from the power source. Insert the key and turn the switch to the right (ON). This will activate the electrical system.Turn the switch to the left (OFF) and remove the key, when parking the machine. This will prevent battery drain.
Never turn off the disconnect switch with the engine running.
Back up Alarm
ALARM Warns that the machine is in reverse. The alarm should sound when the transmission range selector is in REVERSE, with the engine running. ALARM SOUND ADJUSTMENT Adjusts the alarm sound level to (1) HIGH, (2) LOW or (3) MEDIUM to meet job conditions.The alarm is set at HIGH when shipped from the factory.Emergency Exit
The right side cab window can be used as an emergency exit. Unlatch the window and slide it to the rear.Seat Adjustment
Adjust the seat at the beginning of each shift or when changing operators.Adjust the seat to allow full travel of the brake pedal with the operator seated against the seat back.The seat must be adjusted with the operator seated and the engine running.
(1) LATERAL Lift the lever.