GEAR AS-3RD PLANETARY 8U3114 - Caterpillar

Instructions to Connect 417-3764 Signal Converter to the Pressure Sensor
Required Parts
Table 1
Parts List    
Item    Qty    Part Number    Description    
1     1     320-3064     Pressure Sensor    
2     1     417-3764     Signal Converter    
3     1     1J-9671     O-Ring Seal    
4     1     362-1142     Adapter    
5     2     3S-2093     Cable Strap    
6     15     7K-1181     Cable Strap    Perform the following procedure:
Illustration 1 g03330149
(1) 320-3064 Pressure Sensor (2) 417-3764 Signal Converter
Connect one end (A) of the first wired harness to the 320-3064 Pressure Sensor (1) using a three pin 281-8804 Connector Plug As .
Connect the other end (B) of the first wired harness to one end of the 417-3764 Signal Converter (2) using a three pin 102-8803 Receptacle Kit .
Connect the other end of the 417-3764 Signal Converter to one end (C) of the second wired harness using a four pin 155-2271 Connecting Plug Kit .Routing Instructions
Perform the following procedure:
Place all harness wiring in conduit.
Use a knockout to add hole to dog house.
Protect conduit going through hole with a grommet.
Zip tie 417-3764 Signal Converter to existing wiring harness inside doghouse with 3S-2093 Cable Strap .
Place one of the 7K-1181 Cable Straps around center of 417-3764 Signal Converter .
Zip tie conduit to harness as needed with a maximum spacing of 450 mm (18 inch).
Make sure that harness is clipped within 150 mm (6 inch) of each connector.