GEAR ASSEM. (50 T.) 9M7094 - Caterpillar

Know the machine's linkage movement extremes. Keep the work tools away from the cab at all times. Failure to do this could result in personal injury or death.
Know the maximum height and the maximum reach of your machine. Serious injury or death by electrocution can occur if the machine or the work tools are not kept a safe distance from electrical power lines. Keep a distance of at least 3000 mm (118 inch) plus an additional 10 mm (0.4 inch) for each 1000 volts over 50000 volts.
Never swing a load over a truck cab or over workers.Do not swing the linkage into stationery objects. Use the machine hydraulic system to stop the swing. If a sudden stop is required use the swing brake.Repeated stopping by an object can cause structural damage if the front linkage is swung into a bank or an object.With certain attachement combinations, the attachment can hit the cab or front of the machine. Always check for interference with first operating a new work tool.Whenever the wheels of the machine raise off the ground while lifting, lower the machine back to the ground smoothly. DO NOT DROP OR CATCH IT WITH THE HYDRAULICS. Damage to the machine can result.Keep the stick out, when moving the machine, to prevent the clamshell, the grapple or the magnet from swinging into the cab. These attachments can swing in all directions.
Know the location of any buried cables. Mark the locations clearly before you dig.Move the machine whenever the position for lifting is not efficient. The machine can be moved forward or backward at any time during the operating cycle.Use steady, comfortable speeds while you operate the machine.For efficient operation, use more than one control at a time, when possible.Position a truck so that the machine can load the truck from the rear or from the side. Load trucks evenly. This will help you avoid overloading the rear axles.Lifting Objects
To prevent injury, do not exceed the rated load capacity of the machine. If the machine is not on level ground, load capacities will vary.
The grapple or the magnet can swing in all directions. Personal injury can result if the attachment swings into the cab or a person in the work area.
Note: Some local regulations regard the lifting uses of excavators and material handlers. Obey these local regulations.If the machine is equipped with the CE plate per requirements for the European Union, used to lift objects, then the machine must be equipped with the optional boom lowering control valve and an overload warning device.A fit for purpose test was completed in order to confirm that a properly equipped machine meets the requirements of the European Union Machinery Directive "2006/42/EC" for lifting objects.The overload warning device (if equipped) must be adjusted for the bucket linkage and bucket size that is installed on the machine. Adjust the overload warning device for proper operation.The setting for the overload warning device (if equipped) should be checked by an authorized dealer.The use of the overload warning