GEAR AS-OIL PUMP 9P7474 - Caterpillar

Removal Procedure
Start By:
Remove the fuel lines.
Remove the fuel filter assembly.
Remove the oil filter assembly.
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Contact with high pressure fuel may cause personal injury or death. Wait 60 seconds after the engine has stopped to allow fuel pressure to purge before any service or repair is performed on the engine fuel lines.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03872664
Disconnect harness assembly (1) and place out of the way.
Illustration 2 g03872672
Remove bolts (2) and remove tube assembly (3).
Illustration 3 g06228256
Remove bolts (4) and cover (5).
Illustration 4 g06228259
Remove nut (6) and gear (7).
Illustration 5 g06228264
Remove bolts (7) and fuel injection pump (8). Installation Procedure
Install fuel injection pump (8) in the reverse order of removal.
Tighten bolts (4) to a torque of 19 3 N m (168 27 lb in).
Tighten nut (6) to a torque of 105 5 N m (77 4 lb ft).
Tighten bolts (2) to a torque of 44 3 N m (32 2 lb ft) .End By:
Install the fuel injection lines.