GEAR SET 9R2479 - Caterpillar

Table 1
Service Table - Record Of Setpoint Values    
Generator Description: Site, Serial No., EMCP II+ Part Number., etc..    
Engine /Generator Programming OP5-0    
Setpoint    Specified Value    Actual Value (1)    Setpoint Description    Possible Values    Default Value    
P001             Fuel Solenoid Type     0 = ETR, 1 = ETS     0    
P002             Units Shown     0 = Eng, 1 = metric     0    
P003             Shutdown Override For Engine Fault     0 = shutdown,
1 = alarm     0    
P004             Shutdown Enable For Sensor Fault     0 = alarm,
1 = shutdown     0    
P005             Coolant Loss Sensor Installed     0 = w/o sensor,
1 = w/sensor     0    
P006             Shutdown Override For Coolant Loss Fault     0 = shutdown,
1 = alarm     0    
P007             System Voltage     24 volts or 32 volts     24    
P008             This Setpoint Is Not Used.     NA     NA    
P009             Number Of Ring Gear Teeth     95 to 350 teeth     136 teeth for MUI and PEEC engines. 183 teeth for EUI engines.    
P010             Engine Overspeed     500 to 4330 rpm     2120 rpm    
P011             Crank Terminate Speed     100 to 1000 rpm     400 rpm    
P012             Oil Step Speed     400 to 1800 rpm     1350 rpm    
P013             Low Oil Pressure Shutdown At Rated Speed    
34 to 420 kPa (5 to 61 psi)    
205 kPa (30 psi)    
P014             Low Oil Pressure Shutdown At Idle Speed    
20 to 336 kPa (3 to 49 psi)    
70 kPa (10 psi)    
P015             High Water Temperature Shutdown    
85 to 123°C (185 to 253°F)    
107°C (225°F)    
P016             Low Water Temperature Alarm    
0 to 36°C (32 to 97°F)    
21°C (70°F)    
P017             Total Cycle Crank Time     5 to 360 seconds     90 seconds    
P018             Cycle Crank Time     5 to 300 seconds     10 seconds    
P019             Cooldown Time     0 to 30 minutes     5 minutes    
P020             AC Voltage     150V to 30.0 kV     700V    
P021             AC Current Full Scale     75A to 4000A     600A    
P022             GSC+ Engine Number     01 to 08     01    
P023             Engine Type     0 = MUI
1 = GAS
2 = EUI    
P024