GEAR-IDLER 9T6818 - Caterpillar

start by:a) remove floor plate1. Remove eight bolts (1) that hold the drive shaft in position. Remove drive shaft (2).Install Drive Shaft (Direct Drive And Special Application)
1. Put drive shaft (1) in position between the yokes. Install the eight bolts that hold it. Tighten the bolts to a torque of 23 3 lb.ft. (29 4 N m).end by:a) install floor plateDisassemble Drive Shaft (Direct Drive And Special Application)
start by:a) remove drive shaft1. Remove the four bolts that hold the spider and bearing assembly to the yoke.2. Remove strap (4) from both bearings (2).3. Remove bearings (2) and seals (3) from spider (1).4. Check bearings for damage or wear. If bearings have damage or wear, use new parts for replacement.Assemble Drive Shaft (Direct Drive And Special Application)
1. Install new seals on the spider.2. Put 1P808 General Purpose Lubricant in the bearings. Install bearings on the spider.3. Install the spider and bearing assembly on the yoke. Install the bolts that hold the spider and bearing assembly in position. Tighten the bolts to a torque of 25 3 lb.ft. (35 4 N m).