GEAR-RING 9U0973 - Caterpillar

Restoring Display Settings or Machine Settings
Use the "Restore Settings" dialog in order to restore the display settings and/or machine settings that have been previously saved. From this dialog, you can restore the configuration settings of the display. These settings may have been previously saved:
Display settings files
Machine settings filesBe sure to restore the correct machine settings file for your machine. Display settings files can be used for any machine, regardless of type.Note: The machine settings file contains the machine dimensions. Only use the machine settings file on the same machine that the file was created on.Note: When you restore the display settings and/or machine settings, the GPS receiver configuration settings and the brightness settings of the display are not changed.Cat Compaction Control systems are unable to restore the calibration settings for the angle sensor.The "Restore Settings" menu lists the settings files that are available.In order to access the "Restore Settings" menu, complete the following steps:
Illustration 1 g02703822
From the "Setup Menu - Configuration" dialog, press the arrow keys until "Restore Settings" is highlighted.
Illustration 2 g01300299
Press the "OK" key. The "Restore Settings" dialog appears. The "Restore Settings" dialog lists the setting files that are available.
Press the arrow keys in order to select the settings file that you need to select.
Press the "OK" key in order to confirm the settings. In order to close the dialog without selecting a settings file, press the escape key . The "Restore Settings" dialog appears.If you attempt to restore an invalid settings file, a warning message appears.
Caterpillar recommends that you check the "Drum" dimensions when you restore a machine settings file.
Press the "OK" key.
Depending on what was selected in the "Restore Settings" dialog, one of the messages shown in Table 1 will appear:
Table 1
Possible Messages
File Type Message
Display settings Restoring Display Settings. Updating...
Machine settings Restoring Machine Settings. Updating...
Press the escape key in order to go back to the "Setup Menu - Configuration" dialog. Press the escape key again in order to exit the "Setup Menu - Configuration" dialog. The changes take effect immediately.