GENERAL AR 2114628 - Caterpillar

Illustration 36 g06016158
(8) 7X-7729 Hard washer
(9) 457-2247 Engine Compartment shield
(25) 8T-4195 Bolt
(67) 463-1126 Hose As
(73) 2Y-5429 Grommet
(74) 4D-9517 Clip
Route hose assembly (67) through the grommet (73) on the engine compartment shield (9). Refer to Illustration 36.
Secure the hose assembly (67) using clip (74), bolt (25) and washer (8).
Illustration 37 g06016159
(3) 364-9872 Tube As
(67) 463-1126 Hose As
(75) 148-8368 Elbow As
Assemble elbow assembly (75) to the tube assembly (3). Route hose assembly (67) across the engine compartment. Connect hose assembly (67) to elbow assembly (75). Refer to Illustration 37.
Illustration 38 g06016161
Shown with parts removed for clarity
(8) 7X-7729 Washer
(28) 8T-7547 Bolt
(30) 8T-7971 Washer
(64) 8T-4137 Bolt
(67) 463-1126 Hose As
(74) 4D-9517 Clip
(76) 364-9876 Bracket As
(77) 8T-4194 Bolt
(78) 5P-4116 Hard Washer
(79) 198-4766 Hard Washer
Assemble bracket assembly (76) to the machine using bolt (77) and washer (30). Refer to Illustration 38.
Secure hose assembly (67) to bracket assembly (76) using clip (74), washer (8), and bolt (64). Refer to Illustration 38.
Secure hose assembly (67) using clip (74), hard washer (78), hard washer (79) and bolt (28) to engine compartment shield. Refer to Illustration 38.Applying Film
Table 9
Required Parts
Item Qty Part Number Description
80 2 442-6378 Film
81 2 442-6377 Film
Illustration 39 g06006851
(80) 442-6378 Film
(81) 442-6377 Film
Apply film (80) and film (81) to the hood of the machine. Refer to Illustration 39.Installing the Relay
Table 10
Required Parts
Item Qty Part Number Description
82 1 248-2841 Relay As
Illustration 40 g06006843
Location of Relay As
(82) 248-2841 Relay As
Assemble relay assembly (82) in fuse compartment 6. Refer to Illustration 40.Software Configuration and Calibration of the 387-1357 Fan Control Arrangement (Variable Pitch Fan)
Note: This feature can be configured and must be activated with Product Software Programming System (PSPS) or a service tool.
Use a Caterpillar Electronic Technician (Cat ET) and select the proper Electronic Control Module (ECM). Select "SERVICE" from the menu.
Select "CONFIGURATION" from the menu.
Double-click on the desired feature on the configuration screen.
Select the desired status of the feature and click "OK". The feature will be activated on the next power cycle.