GENERATOR AR 1307575 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 140-3073 Spanner Wrench 1
Illustration 1 g01056892
Install shaft (10), washer (12), and nut (13). Tighten nut (13) to a torque of 410 N m (300 lb ft).
Illustration 2 g00776995
Install shim (1) and spacer (11) on shaft 10.
Illustration 3 g00776994
Install bearing cone (9) on shaft (10).
Illustration 4 g00776993
Install two bearing cups (8) in roller (3).
Illustration 5 g00776992
Install roller (3) and bearing cone (7).
Illustration 6 g00776991
Install washer (6).
Illustration 7 g00776990
Install lockwasher (5).
Illustration 8 g00776988
Install locknut (4). Use Tooling (A) and torque locknut (4) to a rolling torque of 23 N m (200 lb in). Loosen locknut (4) and torque to a rolling torque of 8.5 N m (75 lb in). Bend one of the tabs on lockwasher (5) into one of the slots on the locknut.
Illustration 9 g00776987
Install plug (2) in roller (3).
Illustration 10 g01056855
Bend the corners on shim (1).
Repeat Steps 1 through 10 and assemble the opposite side of the footshaft. End By:
Install the footshaft. Refer to Disassembly and Assembly, "Footshaft - Install".