GENERATOR GP-HYDRAULIC 1892990 - Caterpillar

Illustration 4 g00993724
Press OK key (8) . The following screen appears momentarily:
Illustration 5 g00993742
Illustration 6 g00993823
Press OK key (8) :
Illustration 7 g00993825
Ensure that both joystick slide controls are in the neutral position. Then, press OK key (8) :
Illustration 8 g00993899
Move the joystick slide controls simultaneously from the NEUTRAL position to the FORWARD position. Then, simultaneously move the joystick slide controls to the BACKWARD position. Release both joystick slide controls to the NEUTRAL position.Press OK key (8) :
Illustration 9 g00993900
The calibrations for the joystick slide controls have been successfully completed.The following table summarizes the messages that are displayed on line 4 when the calibration procedure is successful.
Table 1
Message Center Display (Line 4)     Description    
"STANDBY"     Contents of the message center before starting calibration.    
"1"     Notice of calibration start.    
"2"     Notice that calibration for the neutral position has started.    
"3"     Calibration is finished for the neutral position. Calibration is beginning for the joystick slide controls.    
"SUCCESS"     The calibration procedure has been completed successfully.    An error code may appear on line 4 of the message center. The table below lists the possible messages that may be displayed during a calibration procedure.
Table 2
Message Center Display     Description of Error     Corrective Action    
"ERROR 01"     An error occurred during the calibration of the other device.     Stop the calibration of the other device and recalibrate this device.    
"ERROR 02 "     An error occurred during the calibration of the other module.     Stop calibration of the other module and recalibrate this module.    
"ERROR 03"     The interlock signal has stopped.     Determine whether a communication link is available to the monitor.    
"FAULT-STEP 1"     Error occurred during joystick slide control to the NEUTRAL position.     Place the joystick slide control in the neutral position. Recalibrate the joystick slide control.    
"FAULT-STEP 2"     An error occurred during neutral data sampling.     Place the joystick slide control in the neutral position. Recalibrate the joystick slide control.    
"FAULT-STEP 3"     An error occurred during full directional lever movement.     Perform the maximum stroke operation at extension and retraction. Recalibrate the joystick slide control when this has been completed.    If any of the following errors occurs during calibration of the joystick slide control, the joystick slide control may be faulty:
"FAULT-STEP 1"
"FAULT-STEP 2"
"FAULT-STEP 3"Replace the joystick slide control, and recalibrate the joystick slide control if any of the above errors occur.When the calibration procedure is complete, press up key (1) until "SERVICE" is highlighted on line 1:
Illustration 10 g00993911
Press right key (4 ) . "EXIT" will appear on line 1:
Illustration 11 g00993917
Press set key (5) :
Illustration 12 g00993938
Press cancel key (7) :
Illustration 13 g00986293
(9) Line 3 displays the currently selected tool. (10) Line 4 is the status for the travel speed.