GENERATOR AR 2351205 - Caterpillar

1. Turn the fuel supply valves at the fuel tank to the "OFF" position.2. Remove two bolts (1) and remove the fuel priming pump.3. Put fuel priming pump (2) in position on the fuel injection pump housing and install the two bolts that hold it in place.4. Turn the fuel supply valves at the fuel tank to the "ON" position.Remove And Install Governor Control Rotochamber
1. Disconnect the air line at the governor control rotochamber.2. Remove the cotter pin and pin (2) from the rod end. Remove nuts (3).3. Put governor control rotochamber (4) in position on the bracket and install the two nuts that hold it in place.4. Put the hole in rod end (3) in alignment with the hole in the lever and install the pin and cotter pin. Connect the air line to the bottom of the rotochamber. 5. With the governor in the full off position as shown, dimension :X: from the center of the pin to the bottom of the bracket must be 82.6 1.5 mm (3.25 .06 in.).