GENERATOR GP - 3156369 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Description Qty
A 138-7575 Link Bracket 1
Illustration 1 g02463390
Install plate (15), bolts (16), the washers, and the nuts to gear motor assembly (11).
Install blower (18) and tighten set screws (17). Note: Adjust blower (18) until a 6 mm (0.23 inch) gap exists between blower (18) and the inlet cone.
Illustration 2 g02463389
Install gear motor assembly (11) and bolts (13).
Illustration 3 g02463388
Connect hose assemblies (12), (10), (8), and (7) to gear motor assembly (11).
Connect harness assembly (9).
Illustration 4 g02463439
Attach Tooling (A) and a suitable lifting device to battery box (5). Install battery box (5) and bolts (6).
Place the cable assemblies into position. Install the clamps, the plate, and bolt (4).
Illustration 5 g02463422
Place vibratory valve block (3) into position and install the bolts.
Illustration 6 g02463420
Connect harness assembly (2) to vibratory valve block (3).
Install harness assembly (1) to the clip. End By:
Install the batteries. Refer to Disassembly and Assembly, "Battery - Remove and Install".