GENERATOR GP 3922048 - Caterpillar

Illustration 2 g00704059Use caution when you are fueling a machine. Do not smoke while you are fueling a machine. Do not fuel a machine near open flames or sparks. Always stop the engine before fueling. Fill the fuel tank outdoors. Properly clean areas of spillage.Follow practices for safe fueling that are described in the "Operation" section of the Operation and Maintenance Manual section and follow local regulations. Never store flammable fluids in the operator compartment of the machine. Battery and Battery Cables
Illustration 3 g00704135Caterpillar recommends the following in order to minimize the risk of fire or an explosion related to the battery.Do not operate a machine if battery cables or related parts show signs of wear or damage. Contact your Caterpillar dealer for service.Follow safe procedures for engine starting with jump-start cables. Improper jumper cable connections can cause an explosion that may result in injury. Refer to Operation and Maintenance Manual, "Engine Starting with Jump Start Cables" for specific instructions.Do not charge a frozen battery. This may cause an explosion.Gases from a battery can explode. Keep any open flames or sparks away from the top of a battery. Do not smoke in battery charging areas.Never check the battery charge by placing a metal object across the terminal posts. Use a voltmeter in order to check the battery charge.Daily inspect battery cables that are in areas that are visible. Inspect cables, clips, straps, and other restraints for damage. Replace any damaged parts. Check for signs of the following, which can occur over time due to use and environmental factors:
Fraying
Abrasion
Cracking
Discoloration
Cuts on the insulation of the cable
Fouling
Corroded terminals, damaged terminals, and loose terminalsReplace damaged battery cable(s) and replace any related parts. Eliminate any fouling, which may have caused insulation failure or related component damage or wear. Ensure that all components are reinstalled correctly.An exposed wire on the battery cable may cause a short to ground if the exposed area comes into contact with a grounded surface. A battery cable short produces heat from the battery current, which may be a fire hazard. An exposed wire on the ground cable between the battery and the disconnect switch may cause the disconnect switch to be bypassed if the exposed area comes into contact with a grounded surface. This may result in an unsafe condition for servicing the machine. Repair components or replace components before servicing the machine.
Fire on a machine can result in personal injury or death. Exposed battery cables that come into contact with a grounded connection can result in fires. Replace cables and related parts that show signs of wear or damage. Contact your Caterpillar dealer.
Wiring
Check electrical wires daily. If any of the following conditions exist, replace parts before you operate the machine.
Fraying
Signs of abrasion or wear
Cracking
Discoloration
Cuts on insulation
Other damageMake sure that all clamps, guards, clips, and straps are reinstalled correctly. This will help to prevent vibration, rubbing against other parts, and excessive heat during machine operation.Attaching electrical wiring to hoses and tubes that contain flammable fluids or combustible fluids should be