GENERATOR AR- 5444222 - Caterpillar

Removal Procedure
Start By:
Remove the air compressor. Refer to Disassembly and Assembly, "Air Compressor - Remove and Install".
Illustration 1 g01175595
Disconnect harness assemblies (2) from speed/timing sensors (1).
Illustration 2 g01175674
Remove bolt (3), washer (4), and bracket (5). Remove speed/timing sensors (1). Remove the O-ring seals from speed/timing sensors (1). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5P-3975 Rubber Lubricant 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g01175674Note: Check the O-ring seals for wear or for damage. If necessary, replace the O-ring seals.
Apply Tooling (A) to the O-ring seals prior to installation. Install speed/timing sensors (1).
Position bracket (5) and install bolt (3) and washer (4). Tighten bolt (3) to a torque of 28 7 N m (21 5 lb ft).
Illustration 4 g01175595
Connect harness assemblies (2) onto speed/timing sensors (1). End By:
Install the air compressor. Refer to Disassembly and Assembly, "Air Compressor - Remove and Install".