GLAND 9T0278 - Caterpillar

Illustration 9 g06139664
277-9416 Connecting Plug Kit
Install the terminal from plus assembly (7), connected to wire 8, into port "H" of the existing 277-9416 Connecting Plug Kit on the machine.
Illustration 10 g06066910
Turn the switch to the On position on the 509-7110 Cable As Flash.
Illustration 11 g06067603
In the Bodas interface, select "Flash Tool" and then "Serial Protocol" from the left side, just below "Available ECUs".
Illustration 12 g06067611
On the right side of the screen, select the same COM port, previously set for the communication with ECU from the "Interfaces Menu". Select the port from the drop-down menu, located within the "communication".
Illustration 13 g06067615
On the left side of the screen, select the software from the "Path Button", under the "Configuration Flashing" box.Note: Select the proper flash file
491-4357 Controller "RC4-4/20" : requires 491-4356 Software.
Illustration 14 g06069657
Once the file has been selected, push the "Start" button to begin the procedure.
Illustration 15 g06067632
Once the procedure begins, a progress bar will start at the bottom of the screen. When the status bar starts to count down, turn the key On, allowing communication between the laptop and the ECM.Note: If the procedure was successfully done, a progress bar will appear, showing the completion percentage.
Illustration 16 g06067634
Once the flashing is complete, verify the software version, by scanning for controllers again.Note: Before beginning to scan for controllers, it is necessary to turn the switch Off on 509-7110 Cable As Flash.Uploading A Saved Configuration
Use the dashboard side port to connect the tractor ECMs to the laptop.Note: The display should show ECM RC4-4/20Note: Use 436-3873 Cable As and 370-8059 Adapter Kit if requested.Note: Connect 509-7110 Cable As Flash between 436-3873 Cable As and the side tractor connector.Note: Make sure that the switch on the 509-7110 Cable As Flash is in the OFF position.Note: Ensure that the hardware key is connected to one of the laptop USB ports.
Energize the machine, by turning the key to the On position.
Enable the gen-on feature.
Illustration 17 g06067758
From the "Diagnosis" menu on the left side of the screen, select the proper ECU from the menu on the left-hand side.
Illustration 18 g06067728
Select the "PC -> controller" from the menu "File Functions" located to the top right side of the screen. Then confirm, by selecting "Yes".
Illustration 19 g06067769
When the window reporting the path is open, search for the configuration file’s location, previously saved and select it.Note: The file extension is ".epr".
The configuration previously saved is now uploaded to the new software application file.