GLASS-FRONT 1654808 - Caterpillar

This warning label is positioned on the cover of the intake duct of the air cleaner. The following information is not applicable to machines that are equipped with an ether starting aid.
Since this machine is equipped with an air inlet heater, ether should not be used for starting. Using ether can create explosions or fires that can cause personal injury or death. Follow the starting procedure in the Operation and Maintenance Manual.
(6) Pressurized System
Illustration 9 g01109238This warning label is located inside the engine compartment next to the cooling system filler cap.
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance.
(7) High Pressure Gas
Illustration 10 g01055412This warning label is positioned on the accumulator.
This system contains high pressure gas. Failure to follow the instructions and warnings could cause an explosion, resulting in possible injury or death.Do not expose to fire. Do not weld. Do not drill. Relieve pressure before discharging.See Operation and Maintenance Manual for charging and discharging. See your Caterpillar Dealer for tools and detailed information.
(8) Relieve Hydraulic Tank Pressure
Illustration 11 g01067344This warning label is located on top of the hydraulic tank.
HYDRAULIC TANKRELIEVE TANK PRESSURE WITH ENGINE OFF BY REMOVING CAP SLOWLY TO PREVENT BURNS FROM HOT OIL.
(9) Improper Connections for Jump Start Cables
Illustration 12 g01067366This warning label is positioned on the circuit breaker panel.
IMPROPER JUMPER CABLE CONNECTIONS CAN CAUSE EXPLOSION RESULTING IN PERSONAL INJURY.BATTERIES MAY BE LOCATED IN SEPARATE COMPARTMENTS. WHEN USING JUMPER CABLES, ALWAYS CONNECT POSITIVE (+) CABLE TO POSITIVE (+) TERMINAL OF BATTERY CONNECTED TO STARTER SOLENOID AND NEGATIVE (-) CABLE FROM EXTERNAL SOURCE TO STARTER NEGATIVE (-) TERMINAL (IF MACHINE NOT EQUIPPED WITH STARTER NEGATIVE TERMINAL, CONNECT TO ENGINE BLOCK.) FOLLOW PROCEDURE IN THE OPERATION MANUAL.
(10) High Pressure Cylinder
Illustration 13 g01065467This safety message is located on the inside surface of the access plate for the track adjuster.
High Pressure Cylinder. Do not remove any parts from the cylinder until all of the pressure has been relieved. This will prevent possible personal injury or death.
(11) Machine Swings
Illustration 14 g01067376This warning label is located in two places on the rear of each side of the machine.
Machine swings. Stay back. Crushing hazard could cause serious injury or death.