GLASS 2269842 - Caterpillar

Illustration 23 g06044981
Install Tooling (E) into shaft assembly (45).
Use Tooling (E) and a suitable lifting device to place the pump with the shaft pointing upwards. The pump assembly at this point weighs approximately 204 kg (450 lb).
Illustration 24 g06044985
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove bolts (46) from bearing flange (47).
Use Tooling (F) and a suitable lifting device to remove bearing flange (47). The weight of bearing flange (47) is approximately 36 kg (80 lb).
Illustration 25 g06044988
Raise the temperature of bearing flange (48) to remove screws (49) and bearings (50).
Illustration 26 g06044990
Remove stop screws (51) from bearing housing (48).
Illustration 27 g06044993
Use a suitable press to remove shaft assembly (45) from bearing flange (48).
Illustration 28 g06044996
Remove retaining ring (52) from shaft assembly (45).
Use suitable press to remove bearing spacer (53) and bearing (54) from shaft assembly (45).
Illustration 29 g06044998
Install Tooling (A) into barrel assembly (55). Use a suitable lifting device to remove barrel assembly (55). Lifting the barrel assembly in this state weighs approximately 36 kg (80 lb).
Remove Tooling (A) from barrel assembly (55).
Illustration 30 g06045003
Removing stroking piston (56) and counter-piston (57) from barrel assembly (55).
Illustration 31 g06045006
Remove used Teflon seal (58) and O-ring seal (59) from stroking piston (56).
Illustration 32 g06045008
Remove used Teflon seal (60) and O-ring seal (61) from counter-piston (57).
Illustration 33 g06045011
Remove gasket (62), screws (63), and port plate (64).
Illustration 34 g06045016
Remove bolts (65) and pump insert (67).
Remove centering plate (66).
Illustration 35 g06045020
Use a suitable press and Tooling (B) to remove bearing (69) from pump insert (68).
Illustration 36 g06045022
Use Tooling (D) to remove dowels (70).
Measure and note the dimensions of swashplate setscrews (71) for the later installation.
Remove swashplate setscrews (71).