GLASS 2435471 - Caterpillar

Ether
Ether is poisonous and flammable.Breathing ether vapors or repeated contact of ether with skin can cause personal injury.Use ether only in well-ventilated areas.Do not smoke while changing ether cylinders.Use ether with care to avoid fires.Do not store replacement ether cylinders in living areas or in the operator's compartment.Do not store ether cylinders in direct sunlight or at temperatures above 40°C (102°F).Discard cylinders in a protective place. Do not puncture or burn cylinders.Keep ether cylinders out of the reach of unauthorized personnel.Lines, Tubes and Hoses
Do not bend or strike high pressure lines. Do not install bent or damaged lines, tubes or hoses.Repair any loose or damaged fuel and oil lines, tubes and hoses. Leaks can cause fires. Contact your Caterpillar dealer for repair or replacement.Check lines, tubes and hoses carefully. Do not use your bare hand to check for leaks. Use a board or cardboard to check for leaks. See "Fluid Penetration" in the "Safety Section" for more details. Tighten all connections to the recommended torque. Replace if any of the following conditions are found.* End fittings damaged or leaking.* Outer covering chafed or cut and wire reinforcing exposed.* Outer covering ballooning locally.* Evidence of kinking or crushing of the flexible part of hose.* Armoring embedded in the outer cover.* End fittings displaced.Make sure that all clamps, guards and heat shields are installed correctly to prevent vibration, rubbing against other parts, and excessive heat during operation.Tire Information
Explosions of air inflated tires have resulted from heat-induced gas combustion inside the tires. The heat, generated by welding or heating rim components, external fire, or excessive use of brakes can cause gaseous combustion.A tire explosion is much more violent than a blowout. The explosion can propel the tire, rim and axle components as far as 500 m (1500 ft) or more from the machine. Both the force of the explosion and the flying debris can cause personal injury or death, and property damage.
If a tire were to blowout, it could cause personal injuries. Use a clip-on chuck and a hose long enough to allow you to stand behind the tread when inflating a tire.
Stand behind the tread and use a self-attaching chuck when inflating a tire.Servicing and changing tires and rims can be dangerous and should be done only by trained personnel using proper tools and procedures. If correct procedures are not followed while servicing tires and rims, the assemblies could burst with explosive force and cause serious personal injury or death. Follow carefully the specific information provided by your tire or rim servicing personnel or dealer.Mounting and Dismounting
This machine can be mounted or dismounted at the left front of the machine.* Mount and dismount the machine only where steps and/or handholds are provided.* Inspect, and when necessary, clean and have repairs made to steps and handholds before mounting and dismounting. * Face the machine when mounting and dismounting.* Maintain a three-point contact (two feet and one hand or one foot and two hands contact) with the steps and handholds.* Never