2627934 GLASS Caterpillar parts
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D LN, 325D, 325D L, 329D L, 330D, 330D L, 330D LN, 330D MH, 336D L, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 374D L, 385C, 385C FS, 385C L, 39...
Rating:
Alternative (cross code) number:
CA2627934
262-7934
2627934
CA2627934
262-7934
2627934
Weight: 50 pounds 22 kg.
EXCAVATOR, WHEELED EXCAVATOR,
This part in 4 request:
Show.
This information for suppliers only!
2025-10-01
2025-06-24
2021-04-23
2019-09-18
Compatible equipment models: 2627934:
Number on catalog scheme:
8
For full view, you need register
Information:
Illustration 1 g03177815
This diagnostic code is recorded when the Input/Output module (I/O module) reads the current of the autonomous stop mode indicator (A-Stop mode indicator) circuit is above normal.Test Step 1. CHECK THE INDICATORS USING A KNOWN GOOD INDICATOR.Note: Use this procedure if only one of the three red indicators are not working when the key start switch is cycled. If two or more indicators are not working, proceed to the next Step.
Turn the key start switch and the disconnect switch to the OFF position.
Swap the indicator suspected to be bad with a known good indicator.
Turn the disconnect switch to the ON position. While the swapped indicator is in view, turn the key start switch to the ON.Expected Result:The new indicator is cycled on with the turn of the key start switch.Results:
OK - The new indicator lights up with the turn of the key start switch. The old indicator light failed in some way.Repair: With the new indicator installed, check the status of the diagnostic code. If the code is no longer active, the old indicator light was fault and the new indicator light is working properly.STOP
NOT OK - The new indicator does not illuminate with the turn of the key start switch.Repair: The problem is not with the indicators. Proceed to Test Step 2.Test Step 2. CHECK THE SIGNAL CIRCUIT FOR A SHORT TO GROUND.
The key start switch and the disconnect switch remain in the OFF position.
Disconnect the machine harness from the indicator lights.
Disconnect the machine harness connectors J1 from the I/O module.
At machine harness connector J1, measure the resistance from the signal contact J1-61 (wire A661-BU) to all possible sources of ground. The possible grounds are contacts: contact J1-13, J1-23, J1-26, J1-27, J1-28, J1-32, J1-45, J1-48, J1-50, andJ1-56. Measure resistance to frame, cabinet, and chassis grounds. Note the resistances.Expected Result:The resistance should be greater than 5000 ohms for each measurement.Results:
OK - The resistance is greater than 5000 ohms. The machine harness is correct. Proceed to test step 3.
NOT OK - The resistance is NOT correct. There is a short in the machine harness. The short is between wire A661-BU and the wire or ground for the contact with the incorrect resistance.Repair: Repair the harness or replace the harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the contacts and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Clear all inactive diagnostic codes.
Cycle the key start switch position from ON to OFF to ON again and allow the machine electronic system time for the self check. The check will power the lights for 2 seconds.
Observe the status of CID 3730 FMI 06.Expected Result:The CID 3730 FMI 06 for the indicator is NOT present.Results:
OK - The diagnostic code is NOT present. The diagnostic code does not exist at this time. The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected.
Cat SIS web machinery list:
Parts glass Caterpillar catalog:
307C, 307D, 311C, 311D LRR, 311F LRR, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 313D, 313D2, 313D2 LGP, 315C, 315D L, 318C, 318D L, 318D2 L, 319D L, 320C, 320C FM, 320C L, 320D, 320D FM, 320D GC...
307C, 307D, 311C, 311D LRR, 311F LRR, 312C L, 312D, 312D L, 312D2, 312D2 GC, 313D, 313D2, 315C, 315D L, 318C, 318D L, 318D2 L, 319D L, 320C, 320C FM, 320C L, 320D, 320D FM, 320D GC, 320D L, 320D LN, 3...
311D LRR, 311F LRR, 312C, 312C L, 312D, 312D L, 312D2, 312D2 GC, 313D, 313D2, 315C, 315D L, 318C, 318D L, 318D2 L, 319C, 319D, 319D L, 320C, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR,...
312C, 315C, 318C, 319C, 319D, 320C, 322C, 323D L, 323D LN, 324D, 324D LN, 325C, 325D, 325D L, 329D L, 330C, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 3...
312C, 312D, 315C, 315D L, 318C, 319C, 319D, 320C, 322C, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L,...
319D, 320C, 322C, 323D L, 323D LN, 324D, 324D LN, 325C, 325D, 325D L, 329D L, 330C, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 374D L, 385C, 3...
311D LRR, 311F LRR, 312D, 312D L, 312D2, 312D2 GC, 313D, 313D2, 315D L, 318D L, 318D2 L, 319D, 319D L, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2 L, 323D L, 323D LN, 324D, 324D ...
311D LRR, 312D, 315D L, 319D L, 320D, 320D FM, 320D LRR, 320D RR, 323D L, 324D, 324D L, 325D, 325D L, 325D MH, 329D L, 330D, 330D L, 330D MH, 336D, 345C, 345C L, 345C MH, 345D, 345D L, 349D, 349D L, 3...
319D, 323D L, 323D LN, 324D, 324D LN, 325D, 325D L, 329D L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 385C, 385C L, M313D, M315D, M316D, M31...
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
312D, 315D L, 319D, 323D L, 324D, 324D L, 324D LN, 325D, 325D L, 329D L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 374D L, 385C, 385C L, 385...
312D, 312D L, 312E, 312E L, 315D L, 316E L, 318E L, 319D L, 319D LN, 320D, 320D L, 320D LRR, 320D RR, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323D L, 323D LN, 323D SA, 323E L, 324D, 324D L, 324E, 32...
311D LRR, 312D, 315D L, 319D L, 320D, 320D FM, 320D LRR, 320D RR, 323D L, 324D, 324D L, 325D, 325D L, 325D MH, 329D L, 330D, 330D L, 330D MH, 336D, 345C, 345C L, 345C MH, 345D, 345D L, 349D, 349D L, 3...
311D LRR, 311F LRR, 312D, 312D L, 312D2, 312D2 GC, 313D, 313D2, 315D L, 318D L, 318D2 L, 319D, 319D L, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2 L, 323D L, 323D LN, 324D, 324D ...
3532004
GLASS
308D, 314D CR, 314D LCR, 314E CR, 314E LCR, 321D LCR
308D, 314D CR, 314D LCR, 314E CR, 314E LCR, 321D LCR
3531912
GLASS
308D, 308E CR, 308E SR, 314D CR, 314D LCR, 314E CR, 314E LCR, 321D LCR
308D, 308E CR, 308E SR, 314D CR, 314D LCR, 314E CR, 314E LCR, 321D LCR
3531939
GLASS
308D, 308E CR, 308E SR, 314D CR, 314D LCR, 314E CR, 314E LCR, 321D LCR
308D, 308E CR, 308E SR, 314D CR, 314D LCR, 314E CR, 314E LCR, 321D LCR
3531938
GLASS
308D, 308E CR, 308E SR, 314D CR, 314D LCR, 314E CR, 314E LCR, 321D LCR
308D, 308E CR, 308E SR, 314D CR, 314D LCR, 314E CR, 314E LCR, 321D LCR
3535917
GLASS
M313D, M315D, M316D, M318D, M318D MH, M322D, M322D MH
M313D, M315D, M316D, M318D, M318D MH, M322D, M322D MH
3490089
GLASS
M313D, M315D, M316D, M318D, M318D MH, M322D, M322D MH, M325D L MH, M325D MH
M313D, M315D, M316D, M318D, M318D MH, M322D, M322D MH, M325D L MH, M325D MH
3457836
GLASS
M313D, M315D, M316D, M318D, M318D MH, M322D, M322D MH, M325D L MH, M325D MH
M313D, M315D, M316D, M318D, M318D MH, M322D, M322D MH, M325D L MH, M325D MH
312D, 315D L, 319D, 323D L, 324D, 324D L, 324D LN, 325D, 325D L, 329D L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 374D L, 385C, 385C L, 385...
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
319D, 323D L, 323D LN, 324D, 324D LN, 325D, 325D L, 329D L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 385C, 385C L, M313D, M315D, M316D, M31...