GLASS 2715053 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Lifting Bracket     2    
B     -     Guide Stud
5/8 - 18 by 8 inch     2    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01686653
Note: Ring gear (4) must be installed with the chamfered side of the teeth upward. The chamfered side of the gear teeth will be facing toward the starting motor when the flywheel is installed.
Raise the temperature of ring gear (4). Install ring gear (4) on flywheel (3) .
Illustration 2 g01683693
Install Tooling (B) in the crankshaft.
Install Tooling (A) and a suitable lifting device on flywheel (3). The weight of flywheel (3) is approximately 120 kg (265 lb). Position the flywheel on the crankshaft.
Position adapter (2) on the flywheel.
Apply clean engine oil to the threads of bolts (1) .
Install bolts (1). Remove Tooling (B). Install bolts (1) in place of Tooling (B) .
Tighten bolts (1) to a torque of 270 40 N m (200 30 lb ft).
Remove Tooling (A) from the flywheel.
Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect".