GLASS-REAR 2914815 - Caterpillar

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
The machine must be level and the parking brake engaged. The oil must be warm and the engine stopped.
Illustration 1 g02663219
Open the crankcase drain valve and allow the oil to drain into a suitable container. Close the crankcase drain valve.
Illustration 2 g02663217
Remove and discard the used oil filter element.
Clean the filter housing base. Make sure that all of the old seal is removed from the filter base.
Apply a thin film of clean engine oil to the seal on the new filter element. Install the new engine oil filter hand tight until the seal of the engine oil filter contacts the base. Note the position of the index marks on the filter in relation to a fixed point on the filter base. Note: There are rotation index marks on the engine oil filter that are spaced 90 degrees or 1/4 of a turn away from each other. When tightening the engine oil filter, use the rotation index marks as a guide.
Tighten the filter according to the instructions printed on the filter. Use the index marks as a guide. For non-Caterpillar filters, use the instructions that are provided with the filter. Note: Use a Caterpillar strap wrench, or another suitable tool, in order to turn the filter to the amount that is required for final installation. Make sure that the installation tool does not damage the filter.
Illustration 3 g00955490
Typical example
Remove engine oil filler cap (2). Fill the engine crankcase with new oil. Clean and install the filler cap. Reference: For information on lubricants and refill capacities, refer to the Operation and Maintenance Manual, "Lubricant Viscosities and Refill Capacities" for the machine that is being serviced.
Start the engine and run the engine at low idle for 5 minutes. Inspect the engine oil filter for leaks. Stop the engine.
Maintain the oil level between the "ADD" and "FULL" marks on dipstick (1). Add oil, if necessary.