GLASS 3134352 - Caterpillar

Removal Procedure
Start By:
Remove the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove".
Remove the air inlet manifold. Refer to Disassembly and Assembly, "Air Inlet Manifold - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00557287
Typical example
Illustration 2 g00634458
3054 Engine
Illustration 3 g00634460
3056 Engine
Remove exhaust manifold nuts or bolts (1) in reverse order of the numbered sequence.
Remove exhaust manifold (2) from the engine.
Illustration 4 g00557351
Typical example
Remove exhaust manifold gaskets (3) from the engine.
Remove old sealant from stud threads.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 5 g00557351
Typical example
Inspect the condition of the gaskets. If the gaskets are damaged, use new parts for replacement. Install exhaust manifold gaskets (3) on the cylinder head. Apply 4C-9507 Retaining Compound to the stud threads.
Illustration 6 g00557287
Typical example
Illustration 7 g00634458
3054 Engine
Illustration 8 g00634460
3056 Engine
Damage to the exhaust manifold can occur if the exhaust manifold is not aligned and tightened correctly.
Install exhaust manifold (2) on the cylinder head.Note: Some of the exhaust manifolds have large clearance holes for the bolts. If a new exhaust manifold is installed ensure that the 148-7132 Ferrule mountings that are supplied with the exhaust manifold are installed.
Install exhaust manifold nuts or bolts (1). Tighten the exhaust manifold nuts or bolts in the numerical sequence to a torque of 44 N m (33 lb ft).End By:
Install the air inlet manifold. Refer to Disassembly and Assembly, "Air Inlet Manifold - Remove and Install".
Install the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".