GLASS 3151299 - Caterpillar

3151299 GLASS Caterpillar parts 422E, 422F, 428E, 428F, 432E, 432F, 434E, 434F, 442E, 444E, 444F

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3151299
315-1299
3151299

Weight: 45 pounds 20 kg.

Buy GLASS 3151299 Caterpillar genuine, new aftermarket tractor parts with delivery
BACKHOE LOADER,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

CTP Caterpillar Rear Glass 3151299 Aftermarket.

$428.54

15 Oct 2021
45.0[20.25] Pounds
US: IronDT

CTP Caterpillar Rear Glass 3151299 Aftermarket.
CTP

This part in 3 request: Show. This information for suppliers only!

#1451236 315-1299

2024-11-04

#395481 315-1299

2019-12-03

#276091 315-1299

2019-02-25

Number on catalog scheme: 10

For full view, you need register

Compatible equipment models: 3151299:

BACKHOE LOADER 422E 422F 428E 428F 432E 432F 434E 434F 442E 444E 444F Caterpillar

Information:

Illustration 1 g01209505
SchematicTest Step 1. Inspect Electrical Connectors and Wiring
Remove the electrical power from the ECM.
Illustration 2 g01209513
Typical left side view (1) J1/P1 ECM connector
Illustration 3 g01209519
P1 ECM connector (P1-40) Engine start switch NO (P1-41) Engine start switch NC (P1-5) Return
Thoroughly inspect connector 1.
Illustration 4 g01209522
Operator controls (steering console) (1) Engine start switch (2) Throttle
Thoroughly inspect connector 1 and thoroughly inspect the connector for switch 2. Refer to diagnostic functional tests Troubleshooting, "Electrical Connectors - Inspect" for details.
Perform a 45 N (10 lb) pull test on the wire in the ECM connector that is associated with the active event code.
Check the ECM connector (allen head screw) for the proper torque. Refer to diagnostic functional tests Troubleshooting, "Electrical Connectors - Inspect" for details.
Check the harness and wiring for abrasion and for pinch points from the user defined shutdown device to the ECM.Expected Result:All connectors, pins, and sockets are completely inserted and coupled. The harness and wiring are free of corrosion, of abrasion, and of pinch points.Results:
OK - The harness and wiring are OK. Proceed to Test Step 2.
Not OK - There is a problem in the connectors and/or wiring.Repair: Repair the connectors or wiring and/or replace the connectors or wiring. Ensure that all of the seals are properly in place and ensure that the connectors are completely coupled.Verify that the repair eliminates the problem.STOPTest Step 2. Check the Status of the User Defined Shutdown Input on Caterpillar Electronic Technician (ET)
Verify that the electrical power is removed from the ECM.
Verify that the engine start switch is in the HOLD position.
Connect Cat ET to the service tool connector.
Restore the electrical power to the ECM. Do not start the engine.
Momentarily push up the engine start switch to the START position.
Observe the status of "User Shutdown" on Cat ET.
Momentarily push down the engine start switch to the STOP position.
Observe the status of "User Shutdown" on Cat ET.Note: Perform this test on both operator control panels.Expected Result:The status of