GLASS 3517041 - Caterpillar

7. Install Tool (A) with the flat end down in the fuel pump housing. Move governor bolt (11) until Tool (A) is in place in the slot in the rack. The racks are now in center (zero) position.8. Remove governor plate (12). If necessary, hold the racks in the zero position against Tool (a) with a screwdriver while the governor plate is removed.
It is possible to remove the entire governor as a unit. The above steps must be followed before the governor can be installed again on the injection pump housing.
Install Governor
Drive assemble (5) and stop (3) must be removed from the governor plate before the governor plate is installed.
1. Install Tool (A) in the fuel injection pump housing. The square end (flat end) must be down. Make sure the correct end of Tool (A) is used. Push the fuel rack in until Tool (A) is in place in the slot (groove). The racks are now in the center (zero) position.2. Install a new gasket on the fuel injection pump housing.3. Put governor plate (2) into position on the injection pump housing. Be sure the dowels on plate (2) are in alignment with the holes in the injection pump housing and the governor linkage is engaged with the left fuel rack. 4. Install stop (3) gear (4). Make sure the special tooth (blind spline) in stop (3) is in alignment with the special tooth (blind spline) on pinion assembly (1). 5. Install drive assembly (5). Make an alignment of the hold in gear (4) with the holes in stop (3) and drive assembly (5). Install the pin that holds the gear (4), stop (3) and drive assembly (5) together. Install the lock ring that hold the pin in gear (4). 6. Install spring (7) on the governor assembly. Install a spring washer, flat washer (8), spring washer and collar (6). 7. Install a new gasket (10) on the governor plate. Install governor housing (9). Install bolts (15) and bolts (14) that hold the governor plate and governor housing to the injection pump housing. Install cover (12).8. Install spring (13) and stop collar (11).9. Check the governor adjustment. See Governor Adjustments in Testing and Adjusting. 10. Install valve (17) in cover (16) with the screen side toward the inside of the valve bore.11. Install valve (17) in cover (16). Install cover (18).12. Connect fuel lines (19) to the governor plate.End By:a. install fuel ratio control (if equipped).Disassemble Governor (Standard Engine)
Start By:a. remove governor 1. Remove plug (4) and gasket. Remove the spring, plunger and washer from the speed limiter.2. Bend the locks down on torque spring assembly (1).3. Remove high idle screw (2) and low idle screw (3). 4. Bend lock (7) down and remove the bolt from control lever (8). Remove shaft (5) and control lever (8).5. Remove the lip type seals and shaft bearings from the housing. 6. Remove seat (9), spring washer, flat washer and spring washer (10). Remove spring washer (11). Remove spring (12). 7.