GLASS-REAR 3906086 - Caterpillar

Illustration 1 g00757845
Turn the battery disconnect switch to the OFF position. Remove the key.
There are two side panels under the platform. One panel is on the right side of the platform and one panel is on the left side of the platform. Remove the side panels in order to gain access to the electrical connectors.
Illustration 2 g00757863
Carefully disconnect the electrical connectors. Make a note of the position of the connector in order to properly reconnect the connector.
Illustration 3 g00757870
The mounting bolts are located in the cab. Remove the four nuts from the mounting bolts. The nuts are located at each corner of the platform.
Four pins are needed when you tilt the platform. The pins are stored under the platform on the front right side.
Install two lifting bolts on the back of the cab. Lift the platform with a hoist until you can install two pins in the front. The pins will hold the platform in place.
Illustration 4 g00659177
Install one pin in the hole on each side of the platform. There is one set of holes that is aligned on each side of the machine. The pins must be through the holes.
Attach an appropriate lifting device to the platform. Carefully raise the platform.Note: Do not attach the lifting device to the brackets that hold the hood down. The brackets are connected to the frame of the machine and the brackets are not connected to the platform.
Illustration 5 g00659186
Continue raising the platform until the front set of holes are aligned. Install the pins in the holes. The pins must be through the holes.
Carefully release the tension in the lifting device.
In order to lower the platform, reverse the procedure for raising the platform.