3C8447 GLASS DOOR Caterpillar parts
Rating:
Alternative (cross code) number:
CA3C8447
3C-8447
3C8447
CA3C8447
3C-8447
3C8447
Weight: 0.14 pounds 0 kg.
For full view, you need register
Information:
Separation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 180-3032 Repair Stand Set 1
B 189-0408 Shackle As 2
C 138-7576 Link Bracket 2 Start By:
Remove the lockup clutch and solenoid valve. Refer to Disassembly and Assembly, "Lockup Clutch and Solenoid Valve (Torque Converter) - Remove". Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g01198326
Install Tooling (B), Tooling (C), and a suitable lifting device to the transmission and the torque converter. The weight of the transmission and torque converter is approximately 2025 kg (4465 lb). Position the transmission and the torque converter on Tooling (A) and suitable blocking.
Illustration 2 g01623384
Disconnect harness assembly (2). Remove cover (1). Remove bracket assembly (3) and position bracket assembly (3) out of the way.
Illustration 3 g01623399
Remove retaining bolts (4).
Illustration 4 g01623387
Disconnect harness assembly (5).
Illustration 5 g01623390
Install Tooling (B), Tooling (C), and a suitable lifting device to transmission housing (7). The weight of transmission housing (7) is approximately 1270 kg (2800 lb).
Remove nuts (6) and transmission housing (7).
Table 1
Required Tools
Tool Part Number Part Description Qty
A 180-3032 Repair Stand Set 1
B 189-0408 Shackle As 2
C 138-7576 Link Bracket 2 Start By:
Remove the lockup clutch and solenoid valve. Refer to Disassembly and Assembly, "Lockup Clutch and Solenoid Valve (Torque Converter) - Remove". Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g01198326
Install Tooling (B), Tooling (C), and a suitable lifting device to the transmission and the torque converter. The weight of the transmission and torque converter is approximately 2025 kg (4465 lb). Position the transmission and the torque converter on Tooling (A) and suitable blocking.
Illustration 2 g01623384
Disconnect harness assembly (2). Remove cover (1). Remove bracket assembly (3) and position bracket assembly (3) out of the way.
Illustration 3 g01623399
Remove retaining bolts (4).
Illustration 4 g01623387
Disconnect harness assembly (5).
Illustration 5 g01623390
Install Tooling (B), Tooling (C), and a suitable lifting device to transmission housing (7). The weight of transmission housing (7) is approximately 1270 kg (2800 lb).
Remove nuts (6) and transmission housing (7).