GLASS 4626225 - Caterpillar

Personal injury or death can result from high voltage.When power generation equipment must be in operation to make tests and/or adjustments, high voltage and current are present.Improper test equipment can fail and present a high voltage shock hazard to its user.Make sure the testing equipment is designed for and correctly operated for high voltage and current tests being made.
Display Window
Table 1
Display Window    
Problem     Cause     Solution    
The display window is blank.     The contrast is too light.     Press the up arrow in order to darken the display.    
The display window is black.     The contrast is too dark.     Press the down arrow in order to lighten the display.    Emergency Power Off Switch
Table 2
Emergency Power Off Switch    
Problem     Cause     Solution    
The system will not restart after the EPO switch has been pressed.     When the EPO switch is pressed, the circuit breaker trips open.     Open the front door and reset the small circuit breaker for the EPO switch.    Fan
Table 3
Fan    
Problem     Cause     Solution    
Fan failure is displayed.
Fans are equipped with flow indicators.     The outlet for the fan is obstructed.     Remove the obstruction from the top of the system.    
The doors for exhaust do not open. Ensure that the doors open and close freely.    
The fans are not plugged into the printed wire board for the Fan Monitor. Ensure that you have good connections.    
The fuses are blown on the printed wire board for the Fan Monitor. Replace any fuses that are blown.    Unstable Vacuum During Initial Start-up
Table 4
Unstable Vacuum During Initial Start-up    
Problem     Cause     Solution    
The vacuum increases during start-up of the system.     Thermal activity within the flywheel causes an increase in pressure. Causes the system to cycle on and off until the pressure for the vacuum equalizes.     Normal condition for initial start-up.    Flywheel Rotation
Table 5
Flywheel Rotation    
Problem     Cause     Solution    
Tachometer reading is 0 or there is no perceptible change in rotor speed.     The flywheel is not charging.     Make sure that the key switch is in the "Online" position.    
Tachometer reading is 0 or there is no discernable change in rotor speed     The flywheel is not charging     Make sure that the key switch is in the ONLINE position    Display Panel
Events and Notices
Table 6
Display Panel    
Problem     Cause     Solution    
The display panel is beeping.     An event has occurred.     Go to the Event Log in order to determine the type of Event that has occurred.    
The system is regularly displaying Notices on the LCD Display.     The system is providing warning indications and may need attention or service.     Keep a record of frequent Notices. Contact your Cat dealer in order to discuss possible maintenance actions.    
Notice event: "System Waiting on Vacuum"
The