GLASS 4812651 - Caterpillar

Table 14
Monitor Menu (cont.)
Monitor Parameter Screen 5 Transmission Oil Level
Washer Fluid Level
Auto Lube Grease Level
Fuel Level Status
Parameter Screen 6 Dig Time
Travel Loaded Time
Dump Time
Travel Empty Time
Total Cycle Time
Productivity Ave Truck Load Time
Ave Delay Time
Ave Cycle Time
Ave Bucket Payload
Ave Truck Payload
Total Weight
Truck Count
Weight/Hour
Fuel/Hour
Weight/Fuel
Illustration 9 g02623300
Monitor Selection screen
Illustration 10 g02623301
Parameter Screen 1
The "Monitor" menu option is entered by selecting "Monitor" from the "Home Menu". The "Home Menu" can be displayed from any screen by pressing the "Home" button. Press the UP button or the DOWN button until the "Monitor" is highlighted to select the menu. Then, press the "OK" button to select the "Monitor" menu. "Monitor" screens one through five each allow the user to view four parameters Monitor screen six displays five parameters. Use the navigation button in order to select the parameter. Also, use the navigation buttons to view a different parameter. Press the "OK" button to attain a list of available parameters. See the Systems Operation, "Menu Contents" section of this manual to view the complete list of available parameters. The list of parameters is under the "Monitor" heading.Parameter Screen 1, 2, and 3
From the “Monitor” menu, use the appropriate arrow button to highlight one of the three “Parameter Screen” options. Then, press the "OK" button. Four chosen parameters are displayed on each Parameter Screen. The parameters can be chosen by the operator from the following:
Imp Oil Temp
TC Oil Temp
Engine Coolant Temp
Engine Speed
Rear Axle Oil Temp
Front Axle Oil Temp
Trans Oil Temp
Ambient Air Temp
Trans Input Speed
Trans Output Speed
Actual Gear
Ground Speed
Atmospheric Press.
Fuel Level
Impeller Clutch PressureParameter Screen 4 and 5
Illustration 11 g02691544
Illustration 12 g02691546Note: The UP and DOWN arrows on these screens do not indicate more options. The arrows take the operator to the previous or next parameter screen.Parameter Screens four and five allow the operator to view the status of fluid levels. The vehicle must not be moving and the transmission must be in neutral to view these screens. The available fluids are:Screen Four:
Hydraulic Oil Level
Steering Oil Level
Engine Oil Level
Engine Coolant LevelScreen Five:
Transmission Oil Level
Washer Fluid Level
Auto Lube Grease Level
Fuel Level StatusParameter Screen 6
Illustration 13 g02691553The UP arrow on this screen does not indicate more options. The arrow takes the operator to the previous parameter screen.Parameter screen six displays a list of five time values. Pressing the "OK" button will reset all of the time values to zero. The available times are:
Dig Time
Travel Loaded Time
Dump Time
Travel Empty Time
Total Cycle TimeProductivity
From the “Monitor” menu, use the appropriate arrow button to highlight the “Productivity” option. Then, press the "OK" button. The following items will be displayed:
Ave Truck Load Time
Ave Delay Time
Ave Cycle Time
Ave Bucket Payload
Ave Truck Payload
Total Weight
Truck Count
Weight/Hour
Fuel/Hour
Weight/FuelService Mode Menu
Illustration 14 g02683916
Home Menu Screen
The "Service Mode" menu option is entered by selecting "Service Mode" from the "Home Menu". The "Home Menu" can be displayed from any screen by pressing the "Home" button. Press the UP button or the DOWN button until the "Service Mode" is highlighted to select the menu. Then, press the "OK" button to select the "Service Mode" menu. The "Service Mode" menu option