GLASS-DOOR 4915004 - Caterpillar

Non-European Lights
Complete Lamp Assemblies
9X1439 - 24 Volt - Flood Lamp9X7169 - 24 Volt - Low Beam Headlamp9X7170 - 24 Volt - High Beam Headlamp9X7779 - 12 Volt - Flood Lamp9X8179 - 12 Volt - Low Beam Headlamp9X8180 - 12 Volt - High Beam HeadlampReplacement Bulbs [(5) Burners]
9X3463 - 24 Volt9W0607 - 12 VoltOther Replaceable Parts (Same For Either Voltage)
9X4174 - Lens Assembly (2)-Flood9X7798 - Lens Assembly (2)-Low Beam Headlamp9X7797 - Lens Assembly (2)-High Beam Headlamp9X3455 - Body Assembly (4)9X4243 - Face Seal (3)9X4244 - Bezel Screw [(1) Four Needed]8T0337 - Terminal Screw [(6) Two Needed]8T4133 - Mounting Nut (9)8T4121 - Mounting Washer (8)3E1857 - Harness Assembly (7)9X9365 - Horizontal Mounting BracketEuropean Lights
Complete Lamp Assemblies
9X1440 - High Beam Headlamp9X1441 - Low Beam Headlamp9X1444 - Low Beam (For use in countries driving on left-hand side.)9X1442 - High Beam Headlight (Yellow)9X1443 - Low Beam Headlamp (Yellow)Replacement Bulb [(5) Burner]
9X7849 - 24 VoltOther Replaceable Parts
9X4175 - Lens Assembly (2) High Beam Headlight9X4176 - Lens Assembly (2) Low Beam Headlight9X4179 - Lens Assembly (2) Low Beam Headlight (Left-Hand Countries)9X4177 - Lens Assembly (2) High Beam Headlight (Yellow)9X4178 - Lens Assembly (2) Low Beam Headlight (Yellow)9X7848 - Body Assembly [(4) All European Lights]9X9865 - Face Seal [(3) All European Lights]9X4244 - Bezel Screw [(1) Four Needed]8T0337 - Terminal Screw [(6) Two Needed]8T4133 - Mounting Nut (9)8T4121 - Mounting Washer (8)3E1857 - Harness Assembly (7)9X9365 - Horizontal Mounting Bracket
Illustration 1. Typical example of a lamp group.
Illustration 2. Location of nut, washer and harness assembly. Typical example.Tighten screws (1) to a torque of 1.10 0.15 N m (10 2 lb in).
Characters on lens (2) MUST be upright for the correct light pattern to be emitted from the lamp assembly.
Tighten nuts to a torque of 1.70 0.25 N m (15 3 lb in).
Bolt head will not turn when it is seated on the bracket. Tighten nut to a torque of 12 4 N m (9 3 lb ft).
Bolt head will not turn when it is seated on the bracket. Tighten nut (9) to a torque of 25 7 N m (18 5 lb ft).