GLASS-REAR 5365660 - Caterpillar

Installation Procedure
Note: O-ring seals, gaskets, and seals should always be replaced. A used O-ring may not have the same sealing properties as a new O-ring seal. A reconditioning procedure should not be degraded because of a low cost component such as an O-ring seal or a gasket. Use 1U-6396 O-Ring Assembly Compound during the assembly procedure.
Illustration 1 g00724179Note: The priority valve weighs 25 kg (55 lb).
Use two people to position the priority valve on the machine. Install four bolts and washers (8) on the priority valve.
Install the O-ring seals and connect hoses (7) and (6) to the priority valve.
Illustration 2 g00724175
Connect wire harness (5) on priority valve (1).
Illustration 3 g00724165
Install the O-ring seals and connect hoses (4), (3), and (2) to priority valve (1). End By:
Fill the transmission system with oil. The capacity of the transmission system oil is 155 L (41 US gal). Refer to Operation and Maintenance Manual, SEBU7247, "Transmission System Oil and Screens - Change/Clean" for the correct procedure.