GOV & FUEL INJ PUMP GP 1W8731 - Caterpillar

4. Put wood blocks between ejector cylinder (1) and sliding floor cylinder (2). 5. At the rod end of the ejector cylinder, remove bolts (3) and cover (4) on both sides. 6. Remove pin (5) to make a separation of the rod end of the ejector cylinder from the ejector. 7. On the front side of the ejector, remove bolts (6) and bar (7) on both sides of the bowl. Lift ejector for clearance and slide ejector forward until rear rollers are out of their track. 8. Turn the ejector and remove roller (8) from each side of the ejector. Lift the roller straight up for removal. 9. Turn the ejector as shown and remove from the bowl. The weight of the ejector is 1150 lb. (518 kg).Install Ejector
1. Fasten a hoist to the lifting eye and install the ejector in the bowl. 2. Install rollers (1) on both sides of the ejector. 3. Slide the ejector to the rear. Put the rear rollers in their track and install pin (2) in the rod end of ejector cylinder.4. Install the cover and the bolts on both sides of the pin. Remove the wood blocks between the cylinders. 5. On the front side of the ejector, install bar (3) and bolts (4) on both sides of the bowl.6. Install rear cover assembly, see INSTALL EJECTOR CYLINDER.end by:a) install elevator