GOVERNOR GP-BSC 20R5436 - Caterpillar

Installation Procedure
Table 1
Tools Needed     A     B    
FT-1897 Adapter     1        
5P-9736 Link Bracket     1        
1P-3533 Carrier Bar         1    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g00682900
Install Orifice (4) and O-ring seals (5) in the transmission.
Install the O-ring seal on the flywheel clutch.
Illustration 2 g00682904
Install Tooling (A) on the rear of flywheel clutch (3). Install Tool (B) in Tooling (A) in order to support the weight of flywheel clutch (3). The weight of flywheel clutch (3) is 48 kg (105.0 lb).
Put flywheel clutch (3) in position in the rear of the transmission. Install the bolts that hold flywheel clutch (3) in place.
Illustration 3 g00682906
Put the gasket, cover (1), and hose (2) in position on the flywheel clutch. Install the six bolts that hold the parts in place.
Fill the transmission and bevel gears with oil. Refer to the Operation And Maintenance Manual for the correct fluid levels and proper filling procedures.