GOVERNOR G- 4W5792 - Caterpillar

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
The screen is serviced at the same maintenance interval as the oil change for the transmission and the torque converter. Clean the screen when the oil has been drained from the torque converter and the transmission. Fill the torque converter and the transmission with oil once the screen has been installed.Refer to Operation and Maintenance Manual, "Torque Converter and Transmission Oil - Change".
Ensure that the machine is parked on a level surface and that the parking brake control is in the ENGAGED position. Ensure that the engine is shut off.
Illustration 1 g03489538
Support bottom guard (1) and remove the bolts from the front of the bottom guard. Carefully lower the front of the bottom guard in order to access the transmission.
Illustration 2 g03417661
Remove cover (2) from the torque converter housing. The screen is located behind the cover. Note: A face seal and a wave washer are located between the cover and the torque converter housing.
Remove the screen and clean all the components that were removed in clean, nonflammable solvent. Replace any damaged components.
Lubricate the seals with the oil that is being sealed and then install the screen.
Install the cover on the torque converter housing.
Raise the front of the bottom guard (1) and secure the bottom guard.