GOVERNOR GROUP 5L4917 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     185-3630     Strap Wrench As     1    Start By:
Remove the belt tensioner. Refer to Disassembly and Assembly, "Belt Tensioner - Remove and Install".
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand.Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or disposal.
Illustration 1 g00743436
Typical example
Use Tool (A) and remove oil filter (1) .
Illustration 2 g00744867
Typical example
Loosen hose clamp (3) and remove hose (2) .
Loosen hose clamp (5) and remove hose (4) .
Illustration 3 g00744868
Typical example
Loosen hose clamp (6) .
Illustration 4 g00744933
Typical example
Remove bolts (8) and washers that fasten pulley (7) to water pump (9) .
Remove pulley (7) from water pump (9) .
Illustration 5 g00743477
Typical example
Remove oil tube (10) in order to remove water pump (9) .
Remove four bolts (11) that hold water pump (9) to the engine. Remove water pump (9) .
Remove the O-ring seal from water pump (9), if necessary.