GOVERNOR AND FUEL INJECTION PUMP GROUP 6N7600 - Caterpillar

Illustration 1 g01192184
Typical example
Attach a suitable lifting device to ejector bucket (8). The weight of the ejector bucket is approximately 5830 kg (12850 lb).
Align the pin bores of ejector bucket (8) and the lift arm assembly.
Illustration 2 g01192187
Typical example
Install shims (12) as required.
Use two people to install pin (13). The weight of pin (13) is approximately 23 kg (50 lb).
Repeat Step 4 and Step 5 for the pin on the other side.
Illustration 3 g01192193
Typical example
Install three plugs (10) to collet (11) .
Apply Tooling (C) to the inside and the outside diameters of collet (11) .
Install collet (11) .
Repeat Step 7 and Step 9 for the collet on the other side.
Illustration 4 g01201890
Typical example
Apply Tooling (C) to the threads of bolt (9) .
Install bolt (9), the washer, and the nut.Note: The collet on one side must not extend farther than the other collet when the bolt and nut are tight.
Tighten bolt (9) and the nut to torque of 1800 200 N m (1330 145 lb ft). After the bolt and nut are tight, hit the collet on each side with a heavy hammer until the torque on the bolt and the nut is less than 950 N m (700 lb ft).
Tighten bolt (9) and the nut again to torque of 1800 200 N m (1330 145 lb ft). Hit each collet