GOVERNOR GP 7E0570 - Caterpillar

Parts Needed
Contact EPG Service to have an inspection tool shipped out to dealership to perform inspection process.
Provide Dealership Number, Contact name, mailing address and phone number.
(309) 578-3694 or (309) 578-6795
Outside North America you could also email above information to:
Simpkins_Raymond_L
Action Required
See the attached Rework Procedure.
Owner Notification
U.S. and Canadian owners will receive the attached Owner Notification.
Service Claim Allowances
All units inspected must have the breaker date codes recorded in the Claims record.
Parts Disposition
For breakers found to be defective outside of North America, Dismantle the cover plate and return only the cover plate for claim approval, making the rest of the breaker inoperable and scrap.
Return all Circuit Breakers that do not pass this inspection process to:
Caterpillar Inc.
Service Claims Room
Attn: Ray Simpkins PI1409
8201 N. University Ave.
Peoria, Illinois 61615
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
Attach.(1-Copy of Owner Notification For U.S. And Canadian Owners(2-Rework ProcedureCopy of Owner Notification For U.S. And Canadian Owners
Rework Procedure
Before performing inspection and possibly replacement of the Circuit breaker, you must read and understand the following safety instructions. After reading the instructions, inspect the breaker to see if it is within the affected date code ranges. If the breaker falls within both of these ranges, then the breaker needs to be inspected for the following potential errors; missing or misoriented internal fibers, and/or missing arc chute stacks. If any of those conditions are found to be present, the breaker must then be replaced.
DANGER Hazard of Electrick Shock, Burn, or Explosion!
* This equipment must be installed and serviced by qualified electrical personnel only.* Turn off all power supplying this equipment before working on or inside equipment.* Always use a properly rated voltage sensing device to confirm power is off.* Replace all devices, doors, and covers before turning on power to this equipment.* It is important to utilize appropriate personal protective devices such as approved safety glasses, and rated safety gloves.Before beginning any of the following procedures, the electrical supply feeding the breaker must be disconnected and safely secured so that there is no voltage to the breaker on either load or supply side.
For package gensets the terminal box side cover needs to be removed to access the breaker to perform the necessary procedures of this service letter. For XQ rental packages the ten bolts holding the sheet metal cover over the back of the breakers needs removed to gain access to circuit breakers to view date codes and possibly remove the breaker for further inspection (there are two breakers affected on XQ125).
INSPECTION:
A. Inspect for Date Codes Involved:
There are two date codes on the product. This notice applicable ONLY to breakers that are within both the manufactured date code range of 98041. The date codes are described below.
* The Manufacturing date code label is located on the right side of the device near the ON end. The label will have a small six-digit number and a large five-digit number. The five digit number is the manufacturing date code. The first digit is a