GOVERNOR GP 7N3870 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments , the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption , service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Aftercooler Core - Clean/Test
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Extender (ELC) - Add
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Oil Level Gauge - Calibrate
Engine Storage Procedure - Check
Fuel System - Prime
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fumes Disposal Filter Service Indicator - Check
Transmission Oil Level - Check
Walk-Around Inspection
Between 250 Service Hours and 1000 Service Hours (or between first and fourth oil change)
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Every 1900 L (500 US gal) of Fuel or 50 Service Hours
Zinc Rods - Inspect/Replace
PM Level 1 - Every 9500 L (2500 US gal) of Fuel or 250 Service Hours or 1 Year
Aftercooler Condensate Drain Valve - Inspect/Clean
Alternator - Inspect
Auxiliary Water Pump - Inspect
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Every 28 500 L (7500 US gal) of Fuel or 750 Service Hours or 1 Year
Fumes Disposal Filter Element - Replace
Every 38 000 L (10 000 US gal) of Fuel or 1000 Service Hours or 2 Years
Aftercooler Core - Clean/Test
Heat Exchanger - Inspect
Turbocharger - Inspect
PM Level 2 - Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours or 2 Years
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Every 190 000 L (50 000 US gal) of Fuel or 5000 Service Hours
Starting Motor - Inspect
Water Pump - Inspect
Every 380 000 L (100 000 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations