GRAPPLE AR-OR 3333135 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5S-1330     Valve Spring Compressor     1    Start By:
Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01061432
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Place the cylinder head assembly in an upright position.
Use Tooling (A) in order to compress valve springs (3) and (4). Remove retainer locks (1) .
Remove Tooling (A). Remove valve rotators (2), valve springs (3) and (4), and bases (5) .
Remove inlet valves (6) and exhaust valves (7) from the cylinder head.Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5S-1330     Valve Spring Compressor     1    
Illustration 2 g01061432
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Lubricate inlet valves (6) and exhaust valves (7) with clean engine oil. Install the inlet valves and exhaust valves in the cylinder head assembly.Note: A small amount of grease can be used to hold the retainer locks in position during installation.
Place the following items on inlet valves (6) and exhaust valves (7) : bases (5), valve springs (3) and (4) and valve rotators (2) .
Use Tooling (A) in order to compress valve springs (3) and (4). Install retainer locks (1) .End By: Install the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Install".