GREASE-3 PCT 5164766 - Caterpillar

8. Attach a hoist and chain to bearing housing support (8), this will be used to lift the drum support assembly. Weight of the drum support assembly is approximately 143 kg (315 lbs.). 9. Make matching scribe marks on bearing housing support (8), outer bearing housing (10), and inner bearing housing (14). 10. Remove the bolts and washers holding the drum support assembly to the drum. If necessary, raise the hoist slightly to remove load from bolts. 11. Insert three of the bolts, removed in the previous step, in the blind holes of outer bearing housing (10).
Do not allow the drum support to drop suddenly when free of the drum. The eccentric weight shaft (16) and shaft end (12) extend into the drum support and could be damaged if the drum support is dropped straight down.
12. Turn the bolts in equally until the drum support is free of the drum.Install Drum Support (Vibratory Side)
1. Install shock mounts to shock mount support (1) if they were removed during disassembly. 2. Attach a hoist and chain to the drum support assembly. Weight of the drum support assembly is approximately 143 kg (315 lbs.). 3. Use the hoist to raise the drum support assembly. Move into place against inner bearing housing (14). Align the scribe marks on the drum support assembly with the scribe marks on inner bearing housing (14). 4. Secure the drum support assembly to inner bearing housing (14) using bolts and washers. Turn the eight bolts in equally drawing the drum support assembly into inner bearing housing (14). Use Loctite 262 on the bolts. 5. Align the splines on the inside of coupling (11) with the splines on shaft end (12). Slide coupling (11) into bearing housing support (8). 6. Move the vibratory motor in place against cover plate (2) and secure with bolts and washers. Use Loctite 262 on the bolts. 7. Attach a hoist and chain to shock mount support (1). Weight of shock mount support is approximately 95 kg (210 lbs.). 8. Use the hoist to raise shock mount support (1). Move into place against bearing housing support (8). 9. Secure the shock mounts to the drum support assembly with bolts, washers, and nuts.End By:a. install drum assemblyDisassemble Drum Support Assembly (Vibratory Side)
Start By:a. remove drum support assembly (vibratory side) 1. Lay drum support assembly on clean, hard surface with cover plate (2) up. 2. Make matching scribe marks on cover plate (2) and bearing housing support (8). 3. Remove the bolts and washers holding cover plate (2) to bearing housing support (8). 4. Remove cover plate (2). 5. Remove the bolts and lock washers holding retainer plate (4) in place. Remove retainer plate (4) and shims (5). 6. Attach a hoist and chain to bearing housing support (8). Weight of drum support assembly is approximately 141 kg (310 lbs.). 7. Turn the drum support assembly over so bearing housing support (8) is on the bottom and outer bearing housing (10) is up. 8. Place