GRILL AS 4165812 - Caterpillar

Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: For more information on the governor, refer to Service Manual, SENR6454, "3114, 3116, & 3126 Engine Governors". The Service Manual, SENR6454 requires the use of a 1U-7326 Governor Calibration Bench. For information on reusability of components in the governor, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8434, "3100 Governor Inspection and General Information for Mechanical Governor Groups Used in 3114, 3116, and 3126 Engines Equipped with Mechanical Unit Injectors (MUI)".
Illustration 1 g00673178
Apply lubricant to the new O-ring seal (1). Install new O-ring seal (1) in the cylinder head.
Illustration 2 g00672733
Apply lubricant to the new O-ring seal (2). Install new O-ring seal (2) on the tube assembly (5).
Illustration 3 g00672742
Install the O-ring seal and tube assembly (5) in the cylinder head.
Illustration 4 g00673180
Apply lubricant to the new O-ring seal (3). Install new O-ring seal (3) on the governor.
Illustration 5 g00673182
Place the governor in position on the engine.
Illustration 6 g00613563
Install the washers and bolts (7) that hold the governor in place.
Illustration 7 g00672755
Install clevis pin (6) in Tooling (B).
Illustration 8 g00672752
Use Tooling (B) to install clevis pin (6) and the clip.
Check the fuel setting adjustment. Refer to Testing and Adjusting, SENR5118.
Illustration 9 g00655975
Use Tooling (A) to slide tube assembly (5) into the governor.
Illustration 10 g00613071
Install clip (4).
Illustration 11 g00613041
Install oil tube assembly (1). Install tube assembly (2) and tube assembly for fuel ratio control (3), if equipped. Plug and cap all connections.
Install the governor control cable. End By:
Install the fuel shutoff solenoid. Refer to Disassembly and Assembly, "Fuel Shutoff Solenoid - Remove and Install".