GRILL 6S4011 - Caterpillar

Start By:
Remove auxiliary water pump.
Illustration 1 g03762436
Illustration 2 g03762479
Illustration 3 g03762497
Remove bolts (1), cover (2), and the shims. Remove port plate (3) from cover (2). Remove O-ring seals (4) .
Illustration 4 g03772771
Illustration 5 g03762516
Place a mark on the bearing housing and the impeller housing to show orientation. Remove bolts (5) and the shims if present. Using a suitable press, remove shaft and bearing housing assembly (7) from impeller housing (6) .
Illustration 6 g03762576
Using Tooling (A), remove bolt (8) and gear (9) .
Illustration 7 g03762578
Illustration 8 g03762597
Remove retaining rings (10) and (11). Position the shaft and bearing housing assembly in a suitable press and remove shaft and bearing assembly (12) from bearing housing (13) .Note: The inner race of the lower bearing will remain on the shaft when the shaft is removed from the bearing housing. The outer race and roller assembly will remain inside of the bearing housing. This is normal per the bearing design.
Illustration 9 g03762617
Using a suitable press, remove shaft (15) from bearing (14) .
Using Tooling (B) and suitable press, remove lower bearing inner race (16) from shaft (15) .
Illustration 10 g03764596
Remove seal collar (17) and O-ring seal (18) .
Illustration 11 g03764616
Using a suitable press, remove bearing race and roller assembly (19) from the bearing housing.
Remove lip seal (20) .
Illustration 12 g03764639
Remove drain plug (26) and the O-ring seal. Remove impeller (21), port plates (22) and (23), impeller (24), and port plate (25) from impeller housing (6) .
Illustration 13 g03764640
Remove tube (27) and the O-ring seal (not shown). Remove seal and spring assembly (28) .
Illustration 14 g03764716
Remove ceramic seal (29) .