GUARD AS-LH 1050930 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01079837
Disconnect the harness assembly. Remove oil pressure solenoid (1) from the valve cover base. Remove the O-ring seal.
Remove nut (2). Remove coil assembly (3) from valve cartridge (4) .Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01079837
Install coil assembly (3) and nut (2) on valve cartridge (4). Tighten the nut to a torque of 10 1.5 N m (89 13 lb in).
Install the O-ring seal on oil pressure solenoid (1). Install the oil pressure solenoid and tighten to a torque of 40 5 N m (30 4 lb ft).
Connect the harness assembly.