GUARD AS 1283000 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 9U-6169 Installer 1
9U-6171 Locator 1
9U-6172 Bolt 2
5P-8247 Hard Washer 1
6V-3303 Bolt 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
To install a new wear sleeve that is complete with a seal, use 169-5464 Quick Cure Primer to clean the outer diameter of the crankshaft and the inside diameter of the wear sleeve. Apply 4C-9507 Retaining Compound to the faces of all the mating parts.
Illustration 1 g00604874
Install a new wear sleeve that is complete with a seal (1) (not shown) with Tool (A), as follows:
Illustration 2 g00604875
Install 9U-6171 Locator (3) onto the crankshaft with 9U-6172 Bolt (4).
Put the new wear sleeve that is complete with a seal in 9U-6169 Installer (2).
Put 6V-3303 Bolt (6) through 5P-8247 Hard Washer (5) and 9U-6169 Installer (2) and thread into 9U-6171 Locator (3).
Push the wear sleeve that is complete with a seal onto the crankshaft until 9U-6169 Installer (2) bottoms out.
Illustration 3 g00604874
Remove Tool (A) and check crankshaft rear seal (1) (not shown) for correct installation. End By:
Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".