GUARD AS 1657474 - Caterpillar

Illustration 1 g03108596
(1) Radiator
(2) Hydraulic Oil Cooler
(3) A/C Condenser
(4) Fuel Cooler
(5) Control Knob
(6) Access Panel
Use the control knob in order to release the hydraulic oil cooler and the A/C condenser. Swing hydraulic oil cooler and condenser away from the radiator.
Using the machine key, open the left and right side access doors to clean the radiator and ATAAC cores. If equipped some access doors will require a wrench to open.
Use compressed air, high-pressure water, or steam to remove dust and other debris from the radiator fins. The maximum air pressure for cleaning purposes must be reduced to 205 kPa (30 psi). The maximum water pressure for cleaning purposes must be below 275 kPa (40 psi). However, the use of compressed air is preferred. Refer to Operation and Maintenance Manual, "General Hazard Information" for Safety information about using pressurized air and water.
Lock the access doors.
Swing the hydraulic oil cooler and the air conditioner condenser back into the operating position.
The fuel cooler does not swing out. The wand must be placed behind the fuel cooler between the fuel cooler and radiator cores to clean out the fuel cooler.
Close and fully latch the radiator grill.