GUARD AS 1746986 - Caterpillar

1746986 GUARD AS Caterpillar parts D4G

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1746986
174-6986
1746986

Weight: 11 pounds 5 kg.

Buy GUARD AS 1746986 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

$13.33

07 Mar 2023
0.35[0.16] Pounds
US: Stocklifts, LLC

Beck Arnley 174-6986 Distributor Cap
Beck/Arnley Matches OE form, fit, and function || Durability tested at 15,000 volts, 248 degrees Fahrenheit and 50Hz || Voltage and heat shock tests are performed to withstand a minimum of 300 hours || Manufactured with high quality material and componentry || Application specific to ensure a correct fit for your vehicle

$9.59

25 May 2021
0.35[0.16] Pounds
US: Stocklifts, LLC

Number on catalog scheme: 10

Caterpillar 1746986 Parts scheme GUARD AS

For full view, you need register

Compatible equipment models: 1746986:

TRACK-TYPE TRACTOR D4G Caterpillar

Information:

This procedure is for later 7000 Series Fuel Injection Nozzles with 40.45 mm (1.593 in.) adapter bores.START BY:a. remove valve covers
Typical Example1. Use tool (A), and disconnect fuel line (1) at both ends. Remove the fuel line from the engine.2. Use tool (B), and remove retainer (2) from the adapter.3. Remove the fuel injection nozzles with tooling (C) as follows:a. Install the 6V6983 Adapter and the 8T3199 Screw into nozzle assembly (3).b. The 8T3198 Tube over the 8T3199 Screw.c. Use the 1B4206 Nut on the 8T3199 Screw to pull the fuel injection nozzle from the adapter.4. Remove compression seal (4) and carbon dam seal (8) from fuel injection nozzle (3).5. Use tool (D), and remove adapter (6) from the cylinder head.6. Remove gasket (7) and seal (5) from adapter (6). The following steps are for installation of the fuel injection nozzles and adapters.7. Use tool (E) to clean the bore in adapter (6). Use an open end wrench or tap driver to turn tool (E).8. Inspect seal (5) for damage or wear. Replace the seal if necessary.9. Put washer (7) and seal (5) in position on adapter (6).10. Put liquid soap in the bores of the cylinder head and in seals (5) in the adapters.11. Put 5P3931 Anti-Seize Compound on the threads of adapter (6), and install the adapter in the cylinder head assembly.12. Use tool (D), and tighten the adapter to a torque of 205 14 N m (150 10 lb.ft.).
Make sure the correct compression seal washer (4) is used when the nozzle assembly is installed in the adapter. Only copper washers are to be used with this adapter.
13. Install compression seal washer (4), and use tool (F) to install carbon dam seal (8) on the fuel injection nozzle.14. Put fuel injection nozzle (3) in position in the adapter, and install retainer (2).15. Use tool (B) to tighten retainer (2) to a torque of 48 7 N m (35 5 lb.ft.).16. Install fuel line (1). Tighten the nuts on the fuel line with tool (A) to a torque of 40 7 N m (30 5 lb.ft.).END BY:a. install valve covers