GUARD ASSEM. 1V4367 - Caterpillar

Illustration 1 g01386863
Access panels have been removed in order to clearly show the components. (1) Drain valve (2) Filter element (3) Oil filler cap
Place a suitable container under the drain valve. Open drain valve (1). Refer to the Operation and Maintenance Manual, "General Hazard Information" for information that pertains to containing fluid spillage.
Allow the oil to completely drain.
Close drain valve (1) .
Remove filter element (2) .Note: Dispose of the used filter element according to local regulations.
Clean the filter housing base. All of the old filter seal must be removed from the filter housing base.
Apply a thin coat of engine oil to the seal of the new filter element.
Install the new filter by hand. When the seal contacts the base, tighten the filter element for an additional 3/4 turn. This will tighten the filter sufficiently.Every new oil filter has rotation index marks that are spaced at 90 degree increments. Use the rotation index marks as a guide for tightening the oil filter.
Remove oil filler cap (3). Fill the crankcase with new oil. See Operation and Maintenance Manual, "Capacities (Refill)". See Operation and Maintenance Manual, "Lubricant Viscosities". Clean the oil filler cap and install the oil filler cap.
Illustration 2 g01386865
(4) Dipstick
Start the engine. Run the engine for two minutes. Inspect the machine for leaks. Stop the machine.
Wait for ten minutes in order to allow the oil to drain back into the crankcase. Check the oil level. Maintain the oil level within the FULL RANGE on the dipstick. If the engine oil is below the full range, add more oil.
Close the engine compartment.