AVSPARE.COM
parts catalog

GUARD GP-LINES 2019927 - Caterpillar


2019927 GUARD GP-LINES Caterpillar parts
Rating:
61
Alternative (cross code) number:
CA2019927
201-9927
2019927
Caterpillar 2019927 GUARD GP-LINES

Buy GUARD GP-LINES 2019927 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

2. Secure the center drive shaft with a lifting sling and a hoist.3. Remove eight bolts (1) and remove center drive shaft (2). The weight of the center drive shaft is 79 kg (175 lb). The following steps are for the installation of the center drive shaft.
When the center drive shaft is installed, it must be installed in phase with the front and rear drive shafts. Be sure all joint groups, yokes and lubrication fittings (front, center, and rear) are in alignment with each other.
Illustration 24. Clean the bearing cap and yoke mounting faces.5. Align the lubrication fitting on each end of the center drive shaft.6. Put center drive shaft (2) in position and install eight bolts (1). Tighten the bolts to a torque of 530 70 Nm (400 50 lb ft). Refer to illustration 2 for the correct tightening sequence.7. Separate the steering frame lock link. See the topic "Separate & Connect Frame Lock Link" in this module.8. Lubricate the center drive shaft. Lubricate the slip spline of the center drive shaft with the machine fully articulated. See the Operation & Maintenance Manual for the correct procedure.


Parts guard Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.