GUARD GP-BOTTOM 2180317 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
(A)     138-7574     Link Bracket     1    
(B)         254 mm (10 inch) of M16 X 20 Threaded Rod     1    
Make sure that the mating surfaces of the travel motor and the final drive are thoroughly clean.
Replace the O-ring seal that is used between the travel motor and the final drive with a new O-ring seal.
Install the O-ring seal on the body of the travel motor. Apply clean hydraulic oil to the O-ring seal.
Illustration 1 g00484238
Fasten Tooling (A) and a suitable lifting device to travel motor (4). Carefully position the travel motor on Tooling (B). Slide the travel motor into the final drive.
Install one of the three bolts (3) that hold the travel motor to the final drive. Remove Tooling (B). Install two remaining bolts (3) .
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 2 g00484237
Install new O-ring seals in the ends of hose assemblies (1) and (2). Connect hose assemblies (1) and (2) to the travel motor. Tighten the two hose assemblies to a torque of 80 7 N m (60 5 lb ft).
Fill the final drive with oil to the correct level. Refer to Operation and Maintenance Manual for the correct filling procedure.End By: Install the travel brake valve. Refer to Disassembly and Assembly, "Travel Brake Valve - Install" in this manual.