GUARD GP-LIFT CYLINDER 2614228 - Caterpillar

Illustration 1 g06013357
Typical example
Table 1
Specification for 375-1722 Stick Cylinder Gp, 417-2657 Stick Cylinder Gp and 418-9038 Stick Cylinder Gp
Item Qty Part Specification Description
1 2 290-9183 Bushing Bore before assembly is 90.21 0.04 mm (3.552 0.002 inch).
Installation depth in the cap assembly is 9.85 0.30 mm (0.388 0.012 inch).
Installation depth in the rod assembly is 10.0 0.5 mm (0.40 0.02 inch).
2 1 7Y-4956 Locknut Before assembly, lubricate the threads all around with 309-6932 Hydraulic Oil.
Torque to 15500 800 N m (11432 590 lb ft).
3 2 191-5604 Ring Lubricate the inside diameter and the outside diameter with clean grease.
4 1 506-2322 Seal As Lubricate the inside diameter and the outside diameter with clean grease.
5 1 191-5605 Ring Lubricate the inside diameter and the outside diameter with clean grease.
A 1 357-4704 Cylinder As Bore is 170.050 0.025 mm (6.6949 0.0010 inch).
B 1 357-4713 Rod As Diameter is 114.930 0.038 mm (4.5248 0.0015 inch).
6 8 7Y-5239 Bolt Torque to 300 30 N m (221 22 lb ft).
Turn to an additional angle of 30 5 degrees.
C 1 375-1723 Head Bore over two lands are 115.63 0.03 mm (4.552 0.001 inch).
7 1 359-7192 Stop Free linear movement of the stop after assembly is 0.50 0.26 mm (0.020 0.010 inch).
8 2 095-0930 Retaining Ring Maximum outside diameter after assembly is 81 mm (3.2 inch).
9 1 231-6843 Seal Ring The slit of the seal ring must turn in the direction of the piston.
10 1 191-5644 Bushing Outside diameter before assembly is 120.148 0.032 mm (4.7302 0.0013 inch).
Thickness is 2.475 0.025 mm (0.0974 0.0010 inch).
11 1 Buffer Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
12 1 U-Cup Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
13 1 Lip Type Seal Lubricate the sealing lip lightly with the lubricant that is being sealed.
14 - - Before assembly, apply green Loctite 648 to the wiper seal groove.